Saves my fingers and hekps removes The PTFE tubing without damaging it.
I have not used the PTFE tube remover but I’m sure it’s fine.
The tool itself works fine for extracting filament. It is readily apparent that the plastic parts were 3D printed as the seams and VFAs are pretty visible. All in all it does what I need it to do.
The mount is terrible. Magnets are nowhere near strong enough to support the tool. It has fallen off numerous times. I even used my own neodymium magnets and they didn’t help. I’ll end up using a command strip to hold it in place. Recommend using 3M tape for future iterations.
Mount is definitely solid quality for their unclogging tool will buy from them again
Looks like a perfect little tool to sit there and help with clogs haven’t been able to use it yet, but it’s definitely solid quality
Funny thing is I had not used this tool until the day this feedback request showed up in my email. It so happens that same day my extruder clogged on my Bambu Labs 3D printer. I followed the steps in the video and was back up an printing in 5
Saved my printer more than once. So much better than the unclogger
This worked great for clearing a couple of clogged nozzles i had sitting around. Look forward to spending less time clearing them goung forward. Great product!
This worked great for clearing a couple of clogged nozzles i had sitting around. Look forward to spending less time clearing them goung forward. Great product!
I can't say much about it, easy purchase, fairly quick shipping. I bought this in an abundance of caution. I have about 1000 hours on my printer and just haven't needed it yet.... weird huh... Bambu lab X1carbon has printed great..... but I'm ready for when it does clog....
This glue was recommended by another 3D Printing enthusiast. It is absolutely fantastic. It bonds quick so you aren’t trying to set pieces together for long periods of time. It fully cures fast as well and the bond is super strong.
If you don’t want to go the route of glue/activator, then this is definitely the choice.
I have purchased 2 of the 1.75 mm diameter and 2 of the 2.85 mm diameter No Cloggers. It is the best tool for the job. Don't waste your time with anything else.
This is the only glue that I have found that makes glueing minis easy.
Order my item on September 14 and still have to received my item. I had to reach out to them asking what the status on my item was. they did respond within 24 hours and said the item was lost and would ship me a new one.