Funny thing is I had not used this tool until the day this feedback request showed up in my email. It so happens that same day my extruder clogged on my Bambu Labs 3D printer. I followed the steps in the video and was back up an printing in 5
Saved my printer more than once. So much better than the unclogger
This worked great for clearing a couple of clogged nozzles i had sitting around. Look forward to spending less time clearing them goung forward. Great product!
This worked great for clearing a couple of clogged nozzles i had sitting around. Look forward to spending less time clearing them goung forward. Great product!
I can't say much about it, easy purchase, fairly quick shipping. I bought this in an abundance of caution. I have about 1000 hours on my printer and just haven't needed it yet.... weird huh... Bambu lab X1carbon has printed great..... but I'm ready for when it does clog....
This glue was recommended by another 3D Printing enthusiast. It is absolutely fantastic. It bonds quick so you aren’t trying to set pieces together for long periods of time. It fully cures fast as well and the bond is super strong.
If you don’t want to go the route of glue/activator, then this is definitely the choice.
I have purchased 2 of the 1.75 mm diameter and 2 of the 2.85 mm diameter No Cloggers. It is the best tool for the job. Don't waste your time with anything else.
This is the only glue that I have found that makes glueing minis easy.
This is a must-have 3D printing accessory. Love supporting this small business, This is my third purchase!
Great glue,quick setup and very strong hold,will definitely be buying more in the future
This tool is a great addition for 3 D printing. A real time saver for clearing issues. I've tried it twice already and quickly resolved jammed or broken filament.
It does unclog stuff as said but the handle and tip protector are all 3d printed. I didn't realize that and it says that nowhere.
Works better than any cold pull method. Only issue I had was the not so perfectly spooled with several tangles causing hard stops, the white elegoo rapid Petg filament it would not melt at the top entry point of the brand new bambu lab high flow hardened steel hot end even at 300c for ten minutes. so the no clogger couldn’t due its job. Not it’s fault the filament quality and consistency matters because once I drilled out most of the filament I was able to melt the rest and use the no clogger and long behold what came out was burnt filament and blobs of clogs. Filament matters and manufactures need to do better. All and all the no clogger is a must buy. I personally bought 3 of them and gave one to my friend
I bought this as I had a jammed hotend that I could not clear when using PLA-CF. This worked great. I now use it regularly to clear my hotend after using PLA-CF so there is no filament left in the hotend so it does not harden inside the unit after the printer has cooled down. I would recommend to anyone with a 3D printer it will come in hand.
Would be nice if the hook was angled so the NoClogger is less likely to fall off when printing. I have my printer on some foam pads.